DS1624S+T&R【PDF 4/18 页】IC THERM/EEPROM DIG 256BYT 8SOIC

DS1624

4 f 1

DATA TRANSFER ON 2-WIRE SERIAL BUS Figure 2

Figure 2 details how data transfer is accomplished on the two-wire bus. Depending upon the state of the

bit, two types of data transfer are possible:

1. Data transfer from a master transmitter to a slave receiver. The first byte transmitted by the

master is the slave address. Next follows a number of data bytes. The slave returns an acknowledge

bit after each received byte.

2. Data transfer from a slave transmitter to a master receiver. The first byte (the slave address) is

transmitted by the master. The slave then returns an acknowledge bit. Next follows a number of data

bytes transmitted by the slave to the master. The master returns an acknowledge bit after all received

bytes other than the last byte. At the end of the last received byte, a not acknowledge is returned.

The master device generates all of the serial clock pulses and the START and STOP conditions. A

transfer is ended with a STOP condition or with a repeated START condition. Since a repeated START

condition is also the beginning of the next serial transfer, the bus will not be released.

The DS1624 may operate in the following two modes:

1. Slave receiver mode: Serial data and clock are received through SDA and SCL. After each byte is

received an acknowledge bit is transmitted. START and STOP conditions are recognized as the

beginning and end of a serial transfer. Address recognition is performed by hardware after reception

of the slave address and direction bit.

2. Slave transmitter mode: The first byte is received and handled as in the slave receiver mode.

However, in this mode the direction bit will indicate that the transfer direction is reversed. Serial data

is transmitted on SDA by the DS1624 while the serial clock is input on SCL. START and STOP

conditions are recognized as the beginning and end of a serial transfer.

发布紧急采购，3分钟左右您将得到回复。

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购